Zoppas PEV8448FBK Uživatelský manuál stáhnout pdf (Strana 22)

Problem Possible cause Remedy

The highest heat setting is set. The highest heat setting has the

same power as the function.

You decreased the heat setting to

Start from and only increase the

heat setting.

You cannot activate the outer ring. Activate the inner ring first.

There is a dark area on the

multiple zone.

It is normal that there is a dark area

on the multiple zone.

The sensor fields become hot. The cookware is too large or you

put it too near to the controls.

Put large cookware on the rear

zones if possible.

comes on.

Automatic Switch Off operates. Deactivate the hob and activate it

again.

comes on.

The Child Safety Device or the Lock

function operates.

Refer to "Daily use" chapter.

and a number come on.

There is an error in the hob. Disconnect the hob from the electri-

cal supply for some time. Discon-

nect the fuse from the electrical sys-

tem of the house. Connect it again.

If comes on again, speak to an

Authorised Service Centre.

If you cannot find a solution...

If you cannot find a solution to the problem yourself,

contact your dealer or an Authorised Service Centre.

Give the data from the rating plate. Give also three digit

letter code for the glass ceramic (it is in the corner of the

glass surface) and an error message that comes on.

Make sure, you operated the hob correctly. If not the

servicing by a service technician or dealer will not be

free of charge, also during the warranty period. The

instructions about the Service Centre and conditions of

guarantee are in the guarantee booklet.

Installation

Warning! Refer to Safety chapters.

Before the installation

Before you install the hob, write down the information

bellow from the rating plate. The rating plate is on the

bottom of the hob.

Serial number ...........................

Built-in hobs

Only use the built-in hobs after you assemble the hob

into correct built-in units and work surfaces that align to

the standards.

Connection cable

• The hob is supplied with a connection cable.

• To replace the damaged mains cable use the

following (or higher) mains cable type: H05BB-F

Tmax 90°C. Speak to your local Service Centre.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 51 52

Komentáře k této Příručce

Žádné komentáře

Zoppas PEV8448FBK Uživatelský manuál Strana 22

Komentáře k této Příručce

Související produkty a manuály pro Sporáky Zoppas PEV8448FBK